To do:
-make scheme readable.
Changes:
Link:
Version 1.00
Version 1.01
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
NOT TESTED - - AS IS
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
-INA226 chips on main board for SMT assembly.
-Shunt resistor for 8A current.
-adding protecting circuit input as in reference note. (TIDU473)
-Version with selectable 16 - I2C addresses.
-Modyfied thickness of thermal reliefs.
-Replaced diodes for available in Lcsc stock.
-Adding more copper GND filling zones.
-Rounded PCB edges.
One more reason to not use the Polyfuse in BLDC circuit:
(...)
All right, the problem was COMPLETELY ELSEWHERE than in the driver. There is a POLYFUSE in the power chain which under noisy circumstances induced by the driver shows very unexpected behaviour. By bridging/removing the fuse the problem disappeared.
(...)
MCT8316Z: Motor stalls - Motor drivers forum - Motor drivers - TI E2E support forums
Part Number: MCT8316Z Tool/software: Hey guys and gals, we are in process of designing an actuator controller using the MCT8316ZT (the 'HW' version). The trouble
e2e.ti.com
Last edited: